Hateemy Sales Corporation
Hateemy Sales Corporation
Send Email
Call 08048429161 88% Response Rate
Search

Home » Products & Services » Pypkote Pipeline Corrosion Resistant Tape


Pypkote Pipeline Corrosion Resistant Tape

Leading Manufacturer of pypkote pipeline corrosion resistant tape from Chennai.

Pypkote Pipeline Corrosion Resistant Tape

REQUEST CALLBACK

Pypkote Pipeline Corrosion Resistant Tape
  • Pypkote Pipeline Corrosion Resistant Tape
  • Pypkote Pipeline Corrosion Resistant Tape
  • Pypkote Pipeline Corrosion Resistant Tape
  • Pypkote Pipeline Corrosion Resistant Tape
Get Best Quote

Thanks for Contacting Us.

Approx. Rs 2,250 / RollGet Latest Price

Product Brochure
Product Details:
Usage/ApplicationIndustrial Use
Width150mm,250mm,500mm and 1000mm
Softening Point65 to 121 Deg C
Thickness4 mm
Penetration3 to 20 At 25 Deg C
Filler20 to 30 %

Description
Pypkote 4 mm is a Pipeline Corrosion Resistant Tape conforming to IS 10221 Appendix B specification. It comprises of a Tar based Polymeric mix supported on a fabric of high tensile strength Fibreglass. The Polymeric mix is specially manufactured to have properties of high softening point, high penetration and high resistance to ageing. Tape is terminated on both exteriors by thermofusible HMHDPE Film which aids in the installation process.
Application is fast and easy. The pipe surface is first cleaned with a wire brush. IWL CS is applied on pipes immediately after cleaning. This is to prevent any further accumulation of rust on the pipe. After the primer is applied on the pipe, it is allowed to dry for about 30 minutes till it becomes touch dry. Before adhering the tape to the pipe, it is advisable to gently heat the primer coated pipe by a run of LPG torch. The bottom surface of the tape is heated by LPG Torch or any heat source. The tape is wrapped either by spiral or circumference method over the pipe. By heating the primer coated pipe and by removing the bottom polyethylene from the tape before wrapping, better adhesion between the tape and pipe is obtained. Overlaps are maintained with a minimum of 12 mm. Afinal coat of White Wash is done immediately over the entire coated pipe. 
Over weld joints, the tape is applied after the necessary welding and testing of the joints are completed. The procedure for application of tape is the same as bare pipe procedure. Overlaps on each side of the weld joints are to be 50 mm. Pypkote tape is recommended for application closer to the time of pipe erection and lowering inside trenches to avoid damages to Pypkote. While in storage, Pypkote Rolls must be stacked properly under cover

Yes! I am interested

 
X


Explore More Products

Contact via E-mail
Contact via SMS
Fakhruddin (Partner)
Hateemy Sales Corporation
279, Ground Floor, Thambu Chetty Street, George Town
Chennai - 600001, Tamil Nadu, India
Call Us: 
Call Response Rate: 88%
Share Us :
F G T L



Home  |   About Us   |  Products & Services  |  Site Map  |   Contact Us

© Hateemy Sales Corporation. All Rights Reserved (Terms of Use)
Developed and Managed by IndiaMART InterMESH Limited

Hateemy Sales Corporation